HomePLANNING GUIDE

LED interactive floor vs projection floor

Compare the delivery method, space preparation and maintenance questions before choosing an interactive floor.

CYDON GAMES · Reviewed 2 October 2026

Two different ways to deliver an interactive surface

An LED floor displays light within the installed floor modules. A projection floor displays imagery onto a separate surface using a projector. The sensing method is a separate design decision; ask each supplier how movement is detected in the actual configuration.

What to check on site

For LED modules, ask about floor build-up, loading, cable routes and access to replace a module. For projection, ask about mounting, throw distance, ambient light, shadows and recalibration. Both need a plan for safe movement, cleaning and session operation.

Compare the full project cost

Compare equipment, content licences, installation, shipping, local duties, commissioning, maintenance and ongoing support. A lower equipment price may not mean a lower total project cost. Ask for the same scope and assumptions in each quotation.

A useful supplier demo

Test the proposed games under conditions similar to your venue. Review responsiveness, visibility, reset steps and maintenance access. Choose according to your audience and operating model; neither technology is universally the right choice.

What makes the floor interactive?

The CYDON handbook describes the GRID example on page 9 as pressure-sensitive illuminated tiles. This is a documented example, not a specification for every LED display. Ask how the selected system detects a foot contact or movement and turns it into a game response.

In LUMOplay’s documented projection setup, the computer runs the software, a projector displays the image and a camera detects movement. Its floor installation guide also includes mounting, cabling and calibration. A projector image alone does not establish a working interactive game.

This external example explains one system architecture. CYDON projection supply and compatibility with LUMOplay are unconfirmed; ask the supplier for the actual equipment and sensing method in each proposal.

CYDON handbook floor example · LUMOplay equipment requirements · LUMOplay floor installation guide

What belongs in a like-for-like quotation?

Ask each supplier to identify the display or floor modules; the sensing hardware, if separate; the computer or controller required; and the selected game software and content rights. Record model names and quantities, and who supplies each item. Do not infer that an LED display has built-in sensing or that a software licence includes a projector and camera.

For mounting, floor preparation, cabling, setup, calibration, operator training and spare parts, mark included, excluded or unconfirmed. Ask which software functions and content remain available if a subscription or update service ends. Compare the same room, audience and operating requirements before comparing total cost.

What should the supplier demo prove?

Visibility: use the proposed game with lighting and floor finish representative of your venue. Review targets at the centre and edges, and ask how projected shadows or obstructed sensor coverage would be handled where applicable.

Interaction: ask the supplier to demonstrate the intended actions, movement across the play area and the proposed group session. Observe missed or unintended responses. A demonstration does not establish a maximum player count or response-time guarantee. Agree on the acceptance criteria for your selected configuration.

Operation and recovery: have the supplier show game start/reset, the operator’s routine, restart recovery and access to a replaceable component. Confirm who restores settings or recalibrates after equipment is moved or replaced. Put the agreed test results and unresolved items in the handover record.

Request a comparable floor-system review

Send your country/city, usable room dimensions and clear height, floor finish, lighting, available mounting positions, selected games, audience and intended session format. State whether the area is dedicated or shared. Label missing measurements or requirements “unconfirmed”, and ask for the component list, responsibilities and demonstration checklist together.